For more recent exchange rates, please use the Universal Currency Converter This page was last updated: 06-Sep 10:07.See each listing for international shipping options and costs.
Behringer Eurolive B115D Replacement Parts Driver With AYou should be able to replace the stock Behringer compression driver with a new one like I did.
I somehow blew the tweeter during a Xome performance Imagine that. Behringer Eurolive B115D Replacement Parts Crack Er OpenSo I figured that Id crack er open and see what going on in there. I went to the hardware store and picked up an extra long Philips screwdriver a 20 inch long one to be exact. I measured things up and you would need at least a 9 inch long shaft on the screwdriver to get these screws out. Most of the screws were the same but there were two that were shorter than the others and the screws used for the handles were different. You dont want one side falling over and yanking too hard on the wires. I also marked each of the wires themselves as woofer and tweeter so I wouldnt get those mixed up. Then I removed the quick disconnects on each set of speaker terminals. Simple enough to remove, right I twisted and turned it but it would not budge. I expended all my vast muscular energy on it and could not get it to twist off. I noticed that the diameter of the compression driver was about the same as an oil filter on a car. A quick measure told me it was 3.5 in diameter. So I went and picked up a cheap oil filter wrench. The magnet in the compression driver did attract the metal on the wrench a bit though. A couple of light taps and some twisting and the driver was off. For a replacement, I wound up going with a Selenium D220TI (8 ohm) available at Parts Express. It cost me 45.84. There was another one available in the 30 40 range but I decided to go wit the D220TI because of the rated power handling. Behringer Eurolive B115D Replacement Parts Drivers Replacements RunSupposedly the original Behringer HF compression drivers replacements run in the 70 80 range. The few places that I found online indicated that they are special order items and it would take a while to get them to me. The specs on the Selenium are better, it was around half the price and I could get it in a few days so the decision was pretty much a no-brainer. There was also another consideration in the decision process the Selenium has a titanium diaphragm and the original Behringer 34T30D8 has an aluminum diaphragm according to the markings on the driver. The Selenium is a lot bigger and heavier that the Behringer counterpart but it screws on to the back of the horn and fits inside the cabinet just fine. The oil filter wrench wont strap around the new driver it was just way too big. I hope that the new Selenium driver will hold up to the abuse I sometimes put it through.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |